10.2. CLFS-Bootscripts-1.0-pre5

The CLFS-Bootscripts package contains a set of scripts to start/stop the CLFS system at bootup/shutdown.

10.2.1. Installation of CLFS-Bootscripts

Important

Unlike other chapters, after installing the bootscripts, do not delete the bootscripts source directory. The bootscripts source directory may be needed later.

Install the package:

make DESTDIR=${CLFS} install-bootscripts

The CLFS startup bootscript is /etc/rc.d/startup, but BusyBox will look for /etc/init.d/rcS to use as its startup script. To ensure BusyBox finds the startup script, create the ${CLFS}/etc/init.d directory and a symlink:

install -dv ${CLFS}/etc/init.d
ln -sv ../rc.d/startup ${CLFS}/etc/init.d/rcS

10.2.2. Contents of CLFS-Bootscripts

Installed scripts: bridge, functions, network, start, stop, and syslog.

Short Descriptions

bridge	Sets up network bridging, if configured
functions	Contains common functions, such as error and status checking, that are used by several bootscripts
network	Sets up network interfaces, such as network cards, and sets up the default gateway (where applicable)
syslog	Starts and stops the system log daemons

Prev
Introduction
Next
Configure mdev
Up
Home